Siemens SIMATIC ET 200pro - 3.5 Assembling special modules and motor starters

The ET 200pro EtherNet/IP module
3.9 Technical specifications
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
49
3.9
Technical specifications
SIMATIC interface module ET 200pro EtherNet/IP interface module: 2 EtherNet ports with
M12 connectors; up to 1 m width connectable to a maximum of 16 power, electronic, or
motor starter modules.
SUPPLY VOLTAGE
Rated
24
V
Lower limit
20.4 V
Upper limit
28.8 V
INPUT CURRENT
From supply voltage 1L+, max.
400 mA (dependent on co
n-
nection module, typ.
POWER LOSSES
Power loss, typ.
6 W
ADDRESS AREA
Addressing volume
Outputs
255 bytes
Inputs
255 bytes
INTERFACES
Supports protocol for EtherNet/IP
Automatic detection of transmission speed
Yes
Transmission rate, max.
100 Mbps
M12 (2 ports)
Yes
PROTOCOLS
Supports protocol for EtherNet/IP
Yes
INTERRUPTS/DIAGNOSTICS/STATUS INFORMATION
Diagnoses
Diagnostic functions
Yes
Diagnostics indication LED
Module Status,
Network Status, and I/O Status
LEDs
Yes
Monitoring 24 V voltage supply ON (green)
Yes
24 VDC power LED
Yes
Connection to network P1 LINK (green)
Yes
Connection to network P2 LINK (green)
Yes
GALVANIC ISOLATION
Between backplane bus and electronics
No
Between supply voltage and electronics
No
Between EtherNet and electronics
Yes