Siemens SIMATIC ET 200pro - Page 33

The ET 200pro EtherNet/IP module
3.7 Device profile: supported CIP objects
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
33
Instance 199 (C7
hex
)
This instance is used to establish a connection based on an existing exclusive owner
connection. The new connection also has the same transmission parameters as the
exclusive owner connection. When the exclusive owner connection is cleared, this
connection, too, is automatically cleared. The data length of this instance is always zero.
Common services for Assembly Object
Service
code
Service available
Service name
Description
Class
Instance
0x0E Yes Yes Get_Attribute_Single Supplies contents of the appropriate
attribute
0x10
No
Yes
Set_Attribute_Single
Modifies an attribute value