Siemens SIMATIC ET 200pro - Page 47

The ET 200pro EtherNet/IP module
3.8 Device profile: vendor-specific objects
ET 200pro distributed I/O EtherNet/IP interface module
Manual, 03/2016, A5E32861915-AB
47
Attribute
ID
Access rule
Name
Data type
Data value
1
When Adapter Object AutoConfig attribute is true: These attributes reflect the nonvolatile configu-
ration parameters and are not used by the Adapter.
2
When an I/O connection is open, setting this attribute returns Device_State_Conflict.
Attribute 5 [SlotStatus] details
The SlotStatus attribute, listed in the table below, reports the operating status of the module
installed:
Status code
Text
Description
0
OK
Module is operating normally.
1
Module error
2
Wrong module
3 No module Slot is empty - no module installed.
4 - 255
Reserved
Attribute 6-13 [Channel<n>Status] details
The Channel<n>Status attributes, listed in the following table, report the operating status of
each channel in the module:
Status code
Text
1
Short circuit
2
Under voltage
3
Over voltage
4
Overload
5
Excess temperature
6
Wire break
7
Over range
8
Under range
9
Internal module error
16
Parameter assignment error
17
Sensor or load voltage missing
18
Fuse defect
19
Communication error
20
Ground error
21
Reference channel error
22
Process interrupt lost
23
Actuator warning
24 Actuator shutoff
25
Fail-safe shutoff
26
External error