Siemens SIMATIC ET 200pro - Page 6

Preface
ET 200pro distributed I/O EtherNet/IP interface module
6 Manual, 03/2016, A5E32861915-AB
Relevant manuals
The following manuals are included on the disk that shipped with your ET 200pro
EtherNet/IP module:
● ET 200pro EtherNet/IP interface module System Manual (this manual)
● ET 200pro distributed I/O System Operating Instructions
● EIP ET200 Configuration Tool User Reference Guide
The following manual is also relevant to the ET 200pro system. They can be found on the
Siemens Industry Online Support (https://support.industry.siemens.com/cs/?lc=en-US)
website:
● ET 200pro Motor starters Manual
Software
In order to configure the ET 200pro EtherNet/IP module, you require the EIP ET200
Configuration Tool software. This software is located on the companion disk that shipped
with your ET 200pro EtherNet/IP module.
Recycling and disposal
Because it is low in contaminants, the ET 200pro EtherNet/IP module is recyclable. Contact
a certified electronic waste disposal company to recycle and dispose of your old equipment
in an environmentally-friendly manner.
Online product support
If you have questions about using the ET 200pro EtherNet/IP module that the documentation
does not address, go to the Siemens Industry Online Support
(https://support.industry.siemens.com/cs/?lc=en-US) website and search on "ET 200pro".