iii
SIMATIC Field PG P4 Manual
A5E00180080-04
Preface
Purpose of the Manual
This manual contains all the information you need for commissioning and using the
SIMATIC Field PG P4 programming device.
It is intended both for programming and testing/debugging personnel who
commission the device itself and connect it with other units (automation systems,
further programming devices) as well as for service and maintenance personnel
who install expansions or carry out fault/error analyses.
Where is this Manual Valid?
This manual is valid for all supplied variations of the SIMATIC Field PG P4 and
describes the state of delivery as of August 2004.
Certifications, Standards and Approvals
Certifications
The device fulfils the following guidelines and certifications:
• EU guideline 73/23/EEC on low voltages
• EU guideline 89/336/EEC on electromagnetic compatibility
• Underwriters Laboratories (UL) to Standard UL 60950, 3rd Edition
• Canadian Standard Association (CSA) to Standard C22.2 No. 60950
Standards and Approvals
The device fulfils the requirements for the CE approval. Approvals for UL and CSA
are available.
Further information on the approvals, certificates, and licenses for your device is
provided in Chapter 1.
Incorporation into the Communications Environment
This manual forms part of the supplied DVD “Backup PG”.
For supplementary instructions on how to handle the software please refer to the
corresponding manuals.
To Next Page
Loading...
Need help?
General
