Siemens SIMATIC Field PG P4 User Manual

Configuring the SIMATIC Field PG P4
5-17
SIMATIC Field PG P4 Manual
A5E00180080-04
5.5 The Power Menu
This menu has the following structure:
PhoenixBIOS Setup Utility
Item Specific Help
ESC Exit
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10
Setup Defaults
Save and Exit
Enter
Help
F1
Advanced Security Boot Version ExitMain
[Enabled] [Disabled]
Switch on/off Power
Savings to conserves
system power.
Power
Resume On Time [On]
Resume Time: [00.00.00]
Hard Disk Timeout: [Disabled]
After Power Failure: [Stay Off]
Power Savings:
[Disabled]
Resume On Modem Ring: [Off]
Speed Step Mode [Recommended]
Fig. 5-12 “Power” Menu
The operating system controls the power management of the Field PG P4 via
ACPI (Advanced Configuration and Power Interface). The BIOS power
management functions can only be used with non-ACPI operating systems.
Power Savings [Disabled] Power management is only controlled via
ACPI.
[Enabled] The power-saving functions are set
Hard Disk Timeout [Disabled] The hard disk does not shut down.
[10, 15, 30, 45] Seconds or
[1, 2, 4, 6, 8, 10, 15] Minutes after the last hard disk access
The next time it is accessed, the hard disk
starts spinning again after a brief delay.
Resume On Time [On] If this function is enabled the
programming device is automatically
switched on at the preset time.
[Off] ’Off’ means this function is disabled.
Resume Time Time for automatic restart
Resume On Modem
Ring
Enabled wakes the system up when an
incoming call is detected on your modem.

Siemens SIMATIC Field PG P4 Specifications

General

Brand	Siemens
Model	SIMATIC Field PG P4
Category	Laptop
Language	English