Configuring And Operating The SIMATIC Field PG P4
3-2
SIMATIC Field PG P4 Manual
A5E00180080-04
3.1 Unpacking and Setting Up the SIMATIC Field PG P4
Unpacking Your SIMATIC Field PG P4
Unpack your SIMATIC Field PG P4 as follows:
1. Remove the packing.
2. Do not throw the original packing away. Keep it if you need to transport the
device at a later time.
Checking the Contents
3. Check the packing list to make sure that no components are missing
4. Check the packing and its contents for any transport damages.
5. Please inform your local dealer of any shipping damages and discrepancies
between contents and packing list.
Entering the Serial number (S VP) and the Ethernet address
6. Enter the serial number (S VP) and the Ethernet address of your
programming device in the table of the Getting Started. You can find the serial
number on the type label attached to the base of the device. The Ethernet
address can be found in the BIOS setup settings in the main menu under the
’Hardware Options’ function.
If the device has to be repaired or has been stolen, it can easily be identified by
these numbers.
Entering the Microsoft Windows “Product Key” from the “Certificate of
Authenticity”
7. Enter the Microsoft Windows “Product Key” from the “Certificate of Authenticity”
(COA) in the table of the Getting Started. You will find the “Product Key” on the
device. You need the Windows “Product Key” if you want to reinstall the
operating system.
To Next Page
Loading...
Need help?
General
