Technical specifications
8.4 Specifications
Basic Panels
Operating Instructions, 04/2012, A5E02421799-03
131
8.4 Specifications
8.4.1 Power supply
CAUTION
Safe electrical isolation
Use only 24 VDC power supply units with safe electrical isolation in accordance with IEC
60364-4-41 or HD 384.04.41 (VDE 0100, Part 410), e.g. to PELV standard.
The supply voltage must be within the specified voltage range. Otherwise, malfunction at
the HMI device cannot be ruled out.
Applies to non-isolated plant configurations:
Connect the connection for GND 24 V from the 24 V power supply output to equipotential
bonding for uniform reference potential. You should always select a central point of
termination.
The following table shows the permitted rated voltage and the corresponding tolerance
range.
Rated voltage Tolerance range
+24 VDC 19.2 to 28.8 V (–20%, +20%)
8.4.2 KP300 Basic and KP400 Basic
Weight
KP300 Basic mono PN KP400 Basic color PN
Weight without packaging Approx. 250 g Approx. 510 g
Display
KP300 Basic mono PN KP400 Basic color PN
Type LCD mono FSTN LCD TFT
Active display area 87 x 31 mm (3.6") 95 x 53.8 mm (4.3")
Resolution 240 x 80 pixels 480 x 272 pixels
Possible colors 4 (only backlighting:
white, red, green, yellow)
256
Contrast control Yes No
Brightness control No Yes
To Next Page
Loading...
