EasyManuals Logo

Siemens SIMATIC HMI Start-Up Instructions

Siemens SIMATIC HMI
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Introduction Release 09/02
1–2 ProTool Co nfig ur ing Win do ws-bas ed S yste ms
Start Up Instr uctions
1.1 ProTool Components
The following two components are supplied with SIMATIC ProTool according to the
version supplied:
Configuration software ProTool/Lite, ProTool or ProTool/Pro CS
(Configuration System)
Process visualization software ProTool/Pro RT (Runtime) and simulation software
for Windows-based systems
Configuration softw are:
The configuration software is used to create projects on the configuration computer
under the following operating systems:
Microsoft® Windows® 98 SE
Microsoft® Windows® ME
Microsoft® Windows® NT 4.0 as of Service Pack 6a
Microsoft® Windows® 2000 as of Service Pack 2
Microsoft® Windows® XP Professional
Runtime software ProTool/Pro RT:
ProTool/Pro RT is implemented to run the project under Windows® in order to visualize
or operate the process on SIMATIC Panel PCs or standard PCs.
The runtime software is provided with a software protection feature. This means that
each Runtime software is installed on a standard PC or SIMATIC Panel PC requires
licensed authorization in order to enable unrestricted operation. If no authorization is
available, ProTool/Pro RT runs in Demo mode.
No authorization is required for Windows-based panels and Multi Panels. It is only
necessary to load the project you have created onto the unit.

Other manuals for Siemens SIMATIC HMI

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC HMI and is the answer not in the manual?

Siemens SIMATIC HMI Specifications

General IconGeneral
BrandSiemens
ModelSIMATIC HMI
CategoryTouch Panel
LanguageEnglish

Related product manuals