Rel ease 0 9/02 Contents
ProTool Co nfig ur ing Win do ws-bas ed S yste ms v
Start Up Instr uctions
Contents
1 Introduction ...................................................................................................1–1
1.1 ProTool Components................................................................................1–2
1.2 Create Project..........................................................................................1–3
1.3 Further information....................................................................................1–4
2 Starting Up Operating Units ......................................................................2–1
2.1 Hardware Structure...................................................................................2–1
2.2 Installing the Software...............................................................................2–3
2.3 Using the Online Help...............................................................................2–4
2.4 Calling in Context Menus...........................................................................2–4
3 Basic Steps ....................................................................................................3–1
3.1 Starting the ProTool Configuration Software ...............................................3–1
3.2 Creating a New Project.............................................................................3–1
3.3 Defining Screen Partitions.........................................................................3–2
3.4 Creating a Start Screen.............................................................................3–4
3.5 Terminating ProTool/Pro RT......................................................................3–5
3.6 Entering and Displaying a PLC Process Value............................................3–6
4 Testing the Project.......................................................................................4–1
4.1 Simulating the Project...............................................................................4–1
4.2 Testing the Project on the Operating Unit...................................................4–2
5 Extend Project with Simple Objects........................................................5–1
5.1 Inserting Graphics in the Start Screen........................................................5–1
5.2 Adding a Second Screen...........................................................................5–1
5.3 Inserting a Bar Graph................................................................................5–3
5.4 Movement of a Graphic Object According to the Process Value...................5–4
5.5 Influencing Bits in the PLC.........................................................................5–5
5.6 Visualizing the Bit Status with Flashing Rectangle.......................................5–6
5.7 Displaying Messages................................................................................5–7
5.8 Archiving Process Values..........................................................................5–8
To Next Page
Loading...
Need help?
General
