Siemens SIMATIC IOT2050 Starterkit - Mounting on DIN Rails; Secure the Mounting Clips

Mounting the device
3.2 Mounting on DIN rails
SIMATIC IOT2050 Starterkit
Product Information, 06/2021, A5E50831253-AA
11
3.2 Mounting on DIN rails
3.2.1 Secure the mounting clips
Requirement
• The DIN rail is installed at the installation site (35 mm standard profile).
• Mounting bracket and mounting clamps
• Two screws
• T8 screwdriver
Secure the mounting clips for vertical mounting
1.
Lay the rail clamp on the rear of
the device.
2.
Fasten the rail clamp with the
supplied screws.