Installation
5.2 Types of installation
SCALANCE SC-600
46 Operating Instructions, 10/2021, C79000-G8976-C453-04
Removal
To remove the device from a DIN rail, follow the steps below:
1. Disconnect all connected cables.
2. If necessary, loosen the knurled screw with your hand or a screwdriver.
3. Lever the securing bar down using a screwdriver as far as it will go.
4. Pull the device away from the bottom of the DIN rail with the bar pulled.
5.2.2 Installation on a standard S7-300 rail
Installing on an S7-300 standard rail
Note
Note the position of the securing bar, see a
lso section “Dimension drawings (Page 73)“.
When supplied, the securing bar is in the wall mounting position. To change the position
of the securing ba
r, refer to the section “Changing the position of the securing bar
49)“.
Figure 5-2 S7-300 mounting rail installation with the securing bar in the wall mounting position.
Securing bar in the wall mounting position (as supplied).
To install the device on an S7-300 standard rail, follow the steps below:
1. Place the second housing guide of the device on the top edge of the standard rail.
2. Swing the device down towards the back against the mounting rail.
3. Loosen the knurled screw with your hand or a screwdriver. The spring mounted
securing bar locks in place.
To Next Page
Loading...
Need help?
General