SCALANCE SC-600
Operating Instructions, 10/2021, C79000-G8976-C453-04
75
Approvals
Approvals issued
Note
Issued approvals on the type plate of the device
- with the exception of the certificates for shipbuilding - have
only been obtained when there is a corresponding mark on
the product. You can check
which of the following approvals have been granted for your product by the markings on
the type plate. The approvals for shipbuilding are an exception to this.
Certificates for shipbuilding and national approvals
The device certificates for shipbuilding and special national approvals can be found in
Siemens Industry Online Support on the Internet:
Link: (https://support.industry.siemens.com/cs/ww/en/ps/15326/cert)
Notes for the manufacturers of machines
The devices are not machines in the sense of the EC Machinery Directive. There is
therefore no declaration of conformity relating to the EC Machinery Directive
2006/42/EC for these devices.
If the devices are part of the equipment of a machine, they must be included into the EU
declaration of conformity procedure by the manufacturer of the machine.
Installation guidelines
The devices meet the requirements if you adhere to the installation and safety
instructions contained in this documentation and in the following documentation when
installing and operating the devices.
• "Industrial Ethernet / PROFINET Industrial Ethernet" System Manual
(https://support.industry.siemens.com/cs/ww/en/view/27069465)
• "Industrial Ethernet / PROFINET - Passive Network Components" System Manual
(https://support.industry.siemens.com/cs/ww/en/view/84922825)
• "EMC Installation Guidelines" configuration manual
(https://support.industry.siemens.com/cs/ww/en/view/60612658)
To Next Page
Loading...
Need help?
General