Siemens SIMATIC PCS 7 - How to Edit the Symbols of the Analog Output Module

Result
3.2.2 How to Edit the Symbols of the Analog Output Module
Introduction
To allocate names to the addresses of the "AO4x12Bit" analog output module, assign symbolic
names and comments for each address in the "Edit symbols" dialog.
The procedure is the same as for the analog input module.
Enter the symbolic names and comments as illustrated in the figure below.
Requirements
● The analog output module is configured in HW Config.
● HW Config is open.
Configuring the hardware and networks
3.2 Editing the symbols in HW Config
Getting Started (V8.1 with APL)
Getting Started, 07/2014, A5E32713210-AA 17