3.4 Saving and compiling data in Netpro
3.4.1 How to Save and Compile the Configurations in NetPro
Introduction
The settings you configured in HW Config for the OS Ethernet interface are accepted by
NetPro. Now save, compile, and check the network configuration.
Requirement
● Configuration has been completed in HW Config.
Procedure
Step Action
1 In the Component view, select the "fast_Prj" project in the left window of SIMATIC Manager.
2 In the right window of SIMATIC Manager, double-click the "Plant bus" object.
The "NetPro" dialog box opens.
3 Select the Network > Save and Compile menu command in NetPro.
The "Save and Compile" dialog box opens.
4 Activate the "Compile and check everything" radio button and
click "OK".
5 Close the "Outputs for consistency check" dialog box.
Configuring the hardware and networks
3.4 Saving and compiling data in Netpro
Getting Started (V8.1 with APL)
Getting Started, 07/2014, A5E32713210-AA 23
To Next Page
Loading...
