Siemens SIMATIC PCS 7 - How to Set the CPU to RUN;P in S7-PLCSIM

8.2 How to Set the CPU to RUN/P in S7-PLCSIM
Introduction
After the objects have been compiled and downloaded, the simulation of the CPU has to be
switched over from the "STOP" state to the "RUN-P" state.
Requirements
● The objects have been compiled and downloaded.
● The program S7-PLCSIM has already been started.
Procedure
Step Action
1 Click the "S7/PLCSIM ..." window in the task bar to open the window.
2 Activate the "RUN-P" check box in the "CPU" window.
Result:
3 In the "S7 PLCSIM1" window, click the "Minimize" button.
Compile and download
8.2 How to Set the CPU to RUN/P in S7-PLCSIM
Getting Started (V8.1 with APL)
54 Getting Started, 07/2014, A5E32713210-AA