Siemens Simatic S7-1500 / ET 200MP - Page 28

Configuring/address space
4.3 Operation of the commissioning editor
Technology module TM FAST (6ES7554-1AA00-0AB0)
Equipment Manual, 04/2023, A5E52301130-AA
27
Parameter
Description
LTMFAST_ControlREC command
Command
Selects the command for LTMFAST_ControlREC for controlling
the TM FAST application:
• Load TM FAST application from flash memory to FPGA: An
application in the FPGA is removed. Then an application in
the non-volatile flash memory is loaded into the FPGA.
• Activate TM FAST application in FPGA: The application previ-
ously loaded into the FPGA is activated.
• Remove TM FAST application from FPGA: An application in
the FPGA is removed.
• Delete TM FAST application from flash memory: An applica-
tion existing in the non-volatile flash memory is deleted.
• Enable debug interface: Access to the FPGA via TM FAST
Debug Connector is enabled (activated).
Note:
The debug interface is only intended for development and
commissioning purposes.
• Disable debug interface: Access to the FPGA via TM FAST
Debug Connector is blocked.
Currently loaded TM FAST application
Application ID
Displays the ID of the TM FAST application loaded into the
FPGA.
User logic version
Displays the user logic version of the TM FAST application load-
ed into the FPGA.
LTMFAST_UserWriteREC length
Displays the length of data record 101 in bytes
LTMFAST_UserReadREC length
Displays the length of data record 102 in bytes
Status of the logic in the flash memory
Application ID
Displays the ID of the TM FAST application present in the flash
memory.
User logic version
Displays the user logic version of the TM FAST application pre-
sent in the flash memory.
Time stamp
Displays the date and time of creation of the upd file or the data
block of the TM FAST application that is located in the flash
memory.
LTMFAST_UserReadREC
DWord m
Displays the value in DWord m of data record 102 (Page 69).
Last error code
Displays the error code (Page 69) of the last error that occurred
(in conjunction with data record 102).
LTMFAST_UserWriteREC
DWord m
Inputs the value for DWord m of data record 101 (Page 68).
Last error code
Displays the error code (Page 68) of the last error that occurred
(in conjunction with data record 101).