Siemens Simatic S7-1500 / ET 200MP - Configurable Software Parameters

Configuring/address space
4.2 Parameters of the configuration software
Technology module TM FAST (6ES7554-1AA00-0AB0)
22 Equipment Manual, 04/2023, A5E52301130-AA
4.2 Parameters of the configuration software
You can use various parameters to define the properties of the technology module. When
parameters are assigned in the user program, the parameters are transferred to the module
with the "WRREC" instruction and data record 128 (Page 58).
You set the parameters of the module as follows:
Parameter setting via ...
Basic procedure
Hardware configuration in STEP 7
(TIA Portal)
1. Insert the module from the hardware catalog under "Technolo-
gy modules".
2. Set the device configuration and the parameters of the module
in the hardware configuration.
3. Download the project to the CPU.
4.
If required, use the functions of the commissioning editor.
Hardware configuration using
GSD file for distributed operation
on the PROFINET IO
1. Install the latest PROFINET GSD file.
The module is subsequently available in the hardware catalog
under "Other field devices > PROFINET IO > I/O".
2. Set the parameters in the hardware configuration.
3.
Download the project to the CPU.
The parameters are listed in the following tables.
Parameters of the TM FAST
The following parameter settings are possible. The default settings of the parameters are
shown in bold in the "Value range" column.
Table 4- 2 Configurable parameters of the configuration software and their defaults
Parameter
Value range
Basic parameters: Diagnostics
Enable diagnostic interrupt on wire break
• Disabled
•
Enabled
Error at digital outputs
• Disabled
• Enabled
Missing supply voltage L+
• Disabled
•
Enabled
Basic parameters: TM FAST application
Load TM FAST application during startup
• Disabled
•
Enabled
Always activate TM FAST application
• Disabled
• Enabled
Reaction to CPU STOP
• Disable all outputs
•
Take over from TM FAST application