Siemens Simatic S7-1500H - Page 162

● To ensure optimal stability, the clearance between the two DIN rail adapters must be no
more than 250mm or less.
PD[
Figure 6-6Distance between two DIN rail adapters
NOTE
Note that, depending on the mounting rail width, the mounting rail adapter can protrude up
to 4mm on each side due to the drill holes.
You can find an overview of the protrusion dimensions for the various DIN rails in the table
below.
Table 6-3Additional lateral space required
Mounting rail Article No. Additional space required with
adapter
• 160.0mm (with drill holes) 6ES7590‑1AB60‑0AA0 4mm
• 245.0mm (with drill holes) 6ES7590‑1AC40‑0AA0 4mm
• 482.6mm (with drill holes) 6ES7590‑1AE80‑0AA0 8mm
• 530.0mm 6ES7590‑1AF30‑0AA0 0mm
• 830.0mm (with drill holes) 6ES7590‑1AJ30‑0AA0 0mm
162
S7-1500R/H redundant system
System Manual, 11/2022, A5E41814787-AD
Installation
6.3 Installing the standard rail adapter