Siemens Simatic S7-1500H - Page 164






Figure 6-8Mounting sequence of the DIN rail adapter to the DIN rail 35mmx7.5mm or 35mmx15mm
Mounting to the standard DIN rail 35mmx15mm
To install DIN rail adapter on the standard DIN rail 35mmx15mm, follow these steps:
1.
Set the clamp onto the standard DIN rail.
2.
The longer transverse edge of the adapter frame points toward the cabinet or box wall
(3).
3.
Place the S7-1500R/H mounting rail on the adapter frame so that the groove in the
S7-1500R/H mounting rail fits into the groove in the adapter frame.
Place the S7-1500R/H mounting rail with the adapter frame onto the clamp (4).
4.
Use screws to fasten the S7-1500R/H mounting rail to the standard rail adapter and the
standard mounting rail (tightening torque 5Nm to 6Nm).
164
S7-1500R/H redundant system
System Manual, 11/2022, A5E41814787-AD
Installation
6.3 Installing the standard rail adapter