Programming the OPC UA client blocks
5.10 Error numbers
CP 443-1 OPC UA
108 Operating Instructions, 01/2017, C79000-G8976-C427-02
0 1 B00080C3 The connection resources of the CPU are temporarily ex-
0 1 B0009085 The maximum memory space for items (64000 bytes) of the
OPC UA client has been exceeded.
The OPC client was not enabled in the configuration.
0 1 B0008723 The read/write job references a non-existent data area in a
Two function blocks were called in one cycle.
0 1 B000F002 OPC UA session not yet established. Call the UA_Connect
0 1 B000F004 Invalid value for the "SyntaxID" parameter in the UDT
Invalid data type in UAAnyPointer
0 1 B000F006 Invalid value for the "RepetitionFactor" parameter in the UDT
Invalid operand area of UAAnyPointer
0 1 B000F010 Invalid operand area in a read or write job: Arrays of inputs,
arrays of outputs, arrays of memory bits, arrays of local data
and arrays of local data of the predecessor block are not
The bit offset must be zero.
Wrong data packet in UA_Connect
Invalid URL of a server end point
Invalid value for Timeout
0 1 B0010004 Invalid value for SessionTimeout
Invalid value for MonitorConnection
Invalid transport profile
Invalid Security procedure
Invalid value for UserIdentityToken
0 1 B001000C No connection establishment to partners with security func-
tions (no authentication if security functions are disabled).
Enable the security functions.
0 1 B0010101 Invalid format of the server end point URL. It must start with
The path of the server end point URL is not supported.
The client must not connect itself to the server of its own CP.
Invalid address. DNS is not supported.
Wrong data packet in UA_NameSpaceGetIndex
0 1 B0030001 Wrong data packet in UA_NodeGetHandleList
Invalid NodeID Identifier
To Next Page
Loading...
