Siemens Simatic S7-400 - Communication; Interfaces Overview

Preface
CP 443-1 OPC UA
4 Operating Instructions, 01/2017, C79000-G8976-C427-02
Purpose of the manual
This manual describes the properties of this device and shows application examples. The
manual supports you when installing, connecting up and commissioning the device. The
required configuration steps for the device are described. You will also find instructions for
operation and information about the diagnostics options of the device.
Required experience
To install, commission and operate the device, you require experience in the following areas:
● General electrical engineering
● Automation engineering / STEP 7
● OPC UA
Abbreviations/acronyms
This manual often uses the following abbreviations/acronyms:
●
CP
The acronym is used instead of the full product name "CP 443-1 OPC UA".
●
PG
Programming device (STEP 7 V5)
●
ES
Engineering station (STEP 7 Professional)
New in this release
● Configuration in STEP 7 Professional
● Setting the SYA bit when forwarding the time to the CPU
● Editorial revision
Replaced edition
Release 07/2016
Current manual release on the Internet
You will also find the current version of this manual on the Internet pages of Siemens
Industry Online Support.
Link: (https://support.industry.siemens.com/cs/ww/en/view/21862/man)
Cross references
In this manual there are often cross references to other sections.
To be able to return to the initial page after jumping to a cross reference, some PDF readers
support the command <Alt>+<Left arrow>.