Siemens Simatic S7-400 - Page 155

03/2013 3 Setting up functions
3.4 Fault services
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-155
Function Description Type
For maintenance procedures that are directly
controlled by the maintenance schedule, this is
the only option for sending a notification indicating
when maintenance procedures are due.
- A
maintena
nce job is
overdue
by x days
With a delay of 0 to 999 days, this trigger can be
used to send notifications that are initiated when
at least one of the selected jobs is overdue.
DISPLAY
SELECTION
(Toggle)
INPUT
(Digits from 0
to 999)
- For an
existing
job is
overdue
remind
every x
days
To serve as a reminder, notifications will
repeatedly indicate if a job is overdue. The
intervals between repeat notifications can be
specified in days (between 0 and 999).
DISPLAY
SELECTION
(Toggle)
INPUT
(Digits from 0
to 999)
Maintenance
schedules
The list of maintenance schedules can be used to
select maintenance jobs to be triggered when they
are due. The trigger will respond when at least
one job on the list is due.
DISPLAY
SELECTION
(Toggle)