03/2013 3 Setting up functions
3.5 Global settings
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-187
3.5 Global settings
3.5.1 Setting the notification limit
Function description
The notification limit function permits a repetition delay to be set for a selectable
time, during which no notifications are sent after the initial one. This prevents, for
example, a glut of alarms being output in the event of a faulty configuration or
trigger signal.
Fig. 3-70: Setting the notification limit
Function Description Type
Status
Active
Switches the notification limit for the machine
on/off.
Note:
This setting is activated immediately after storage
of a change.
SELECTION
Do not
send any
messages
for
Time for the notification limit.
The configuration of the notification limit can be
transferred to other control monitors. See Section:
Control monitor - Detailed view
INPUT
SELECTION
INPUT
1 to
1440 minutes
1 to 24 hours
Note
When the notification limit is active, all events are recorded in the event history.
However, the first notification is sent within the set time window in order to
prevent, if necessary, an overflow in the mailbox.
To Next Page
Loading...
