3 Setting up functions 03/2013
3.5 Global settings
© Siemens AG 2006-2013 All Rights Reserved
3-188 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3.5.2 PLC and NC settings
Function description
To be able to use PLC triggers, PLC conditions, and PLC traces on a machine, the
data blocks for the machine used in the control must be disclosed and the
performance for the SINUMERIK Integrate functions must be released.
Feedback messages must be configured (data format) so that they can be sent to
the PLC via DB10 DBB118 to DBB121 in a SINUMERIK, and a freely configurable
data block area in a SIMATIC system.
An AC marker must be configured in order to perform axis tests.
Fig. 3-71: Basic settings for the feedback messages to the PLC
Function Description Type
PLC data blocks for data storage
PLC trigger
configurations
Number of the data block for PLC trigger
configurations (number only; without DB)
DISPLAY
INPUT
Digits from 0
to 9999
PLC trace
configurations
Number of the data block for PLC trace
configurations (number only; without DB).
DISPLAY
INPUT
Digits from 0
to 9999
PLC trace
data
Number of the data block for PLC trace data
(number only; without DB)
• Digits from 0 to 9999
• PLC performance index
• Display and input
• Digits from 1 to 100
DISPLAY
INPUT
To Next Page
Loading...
