03/2013 3 Setting up functions
3.4 Fault services
© Siemens AG 2006-2013 All Rights Reserved
SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
3-161
Fig. 3-45: Example, PLC variable - selection: Variable monitor counter
Function Description Type
Name Name of the new trigger. DISPLAY
INPUT
(max. 40
characters; all
characters are
permissible,
exception <)
PLC monitor Display all possible PLC monitors for which a
trigger can be initiated.
ACTION
Selection The variable can be marked for use once per
trigger. Any number of variables can be
selected.
SELECTION
Each trigger can be assigned a label, which determines its behavior at the central
start date for maintenance.
See also Section Editing the master data of a machine and the general description
of the trigger in Section: Setting up functions.
Options:
• If a label has been set and a start date, which has not yet been reached, has
been configured in the master data, the trigger will not be initiated.
• If the date has been reached or is in the past, the trigger will be initiated
according to the conditions set for it.
• If a start date has not been configured, or the label has not been set, the
trigger will be initiated according to the conditions set for it.
To Next Page
Loading...
