6 Administration 03/2013
6.1 Management of the organization
© Siemens AG 2006-2013 All Rights Reserved
6-296 SINUMERIK Integrate AMB, AMC, AMM, Function Manual (FH) - 03/2013
Function Description Type
Machine-related settings
PLC performance
identification
number
Release of PLC resources for
SINUMERIK Integrate:
See also: Control monitors
The higher the value, the more functions
can be implemented with
SINUMERIK Integrate.
Default value: 50
DISPLAY
INPUT
[Values
between
1 and 100]
Block new
configurations
Switches all machines to "Standby". SELECTION
(Toggle)
Common start date When creating control monitors for
maintenance procedures, if you always
want to start automatically with the same
common maintenance start date, you can
specify the date here.
Independent of this, participation in a
common start date can be individually
defined for each control monitor.
SELECTION
(Toggle)
E-mail notifications Because e-mail notifications only have the
machine ID of the machine owner for
identification (the released responsible
service organization may use a completely
different ID), you also have the option of
sending additional information about the
location, company, and production unit
along with the e-mail.
SELECTION
(Toggle)
Response to
changes of
measuring series
The following applies when prompting
before resetting the contour monitoring:
• Not selected: After a change relevant
for the axis test, a one-time manual
execution of the axis test is required in
order to be able to execute this
automatically
• Selected: An existing successful
execution can be confirmed after a
change relevant for the axis test so that
a manual axis test does not have to be
performed again
SELECTION
(Toggle)
To Next Page
Loading...
