Siemens SIMODRIVE POSMO A

ix
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
The following inter–relationships exist between the version of the posi-
tioning motor, drive software release, motor type and SimoCom A:
Table 1-1 Version, software release, motor type, SimoCom A
Motor version
(stamped on the motor)
Software re-
lease
Use SimoCom A
75 W motor 300 W motor 75 W motor 300 W motor can be re-
placed
Version
A – 1.0 yes no no –
B – 1.1 yes no no –
C – 1.1 yes no no –
D – 1.2 yes no no –
E – 1.2 yes no no –
F – 1.3 yes no no –
G, H A 1.4 yes yes no –
J, K B, C 1.5 yes yes yes 1.0, 2.0, 3.0
L D 1.6 yes yes yes 3.0
M E 2.0 yes yes yes 4.0
N F 2.1 yes yes yes 4.2
O G 3.0 yes yes yes 4.3
P H 3.1 yes yes yes 4.5
Q J 3.2 yes yes yes 4.5, 5.2, 5.3
Information about the positioning motor can be read from the following parameters:
P0052 HW version
P0053 SW version
P0964 (from SW 1.4) Device identification (refer to Section 5.6.2)
Startup and operation of the device/equipment/system in question must
only be performed using this documentation. Only qualified personnel
should be allowed to commission and operate the device/system.
Qualified personnel as referred to in the safety instructions in this
documentation are persons authorized to start up, ground, and label
devices, systems, and circuits in accordance with the relevant safety
standards.
Motor version,
software version,
motor type,
SimoCom A
Definition:
Who are
qualified
personnel?
Foreword
06.0510.0705.13