xii
E Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
Note
When handling cables, observe the following:
S They are not damaged,
S they are not stressed,
S they may not come into contact with rotating components.
!
Warning
When testing the voltage of the electrical equipment of the machines
on the system side, all of the SIMODRIVE drive unit connections must
be withdrawn or disconnected (EN 60204–1 (VDE 0113–1), Pt. 20.4).
This is necessary, as the SIMODRIVE insulation has already been
tested, and should not be subject to a new test (additional voltage
stressing).
!
Warning
Start–up/commissioning is absolutely prohibited until it has been
ensured that the machine in which the components described here are
to be installed, fulfills the regulations/specifications of the Directive
98/37/EC.
!
Warning
The information and instructions in all of the documentation supplied
and any other instructions must always be observed to eliminate
hazardous situations and damage.
S For implementing special versions of machines and equipment,
the data and specifications in the Catalogs and quotations
additionally apply
S Further, all of the relevant national, local land plant/system–specific
regulations and specifications must be taken into account.
S All work should be undertaken with the system in a no–voltage
condition!
Caution
When using mobile radio equipment (e.g. cellular phones,
walkie–talkies) with a transmitting power of > 1 W close to
SIMODRIVE POSMO A (< 1.5 m), this can have a negative impact on
the functioning of the SIMODRIVE POSMO A.
06.05
To Next Page
Loading...
Need help?
General