Siemens SIMODRIVE POSMO A User Manual

5
5.2 ”Speed setpoint” mode (P700 = 1) (from SW 2.0)
5-139
 Siemens AG 2013 All Rights Reserved
SIMODRIVE POSMO A User Manual (POS1) – 08/2013 Edition
5.2.6 Parameters for n–set operation
The following parameters are used for the general parameterization in
the ”speed setpoint” mode:
 P8 Maximum speed
 P9 Ramp–up time
 P25 Override, acceleration
 P58 Holding brake, brake opening time
 P59 Speed, close holding brake
 P60 Holding brake, brake delay time
 P61 Holding brake, controller inhibit time
 P700 Selector switch mode
 P880 Normalizing N–SET
 P930 Actual operating mode
 P1426 Tolerance bandwidth, speed actual value
 P1427 Delay time Nset reached
5.2.7 Terminal signals
It is not possible to feed back the terminal signals as was the case pre-
viously (pos mode). This is because the feedback signal byte (RMB) is
used to display the speed actual value.
The relevant bits of the control and status word in the n–set mode are
interlocked with the terminals using the appropriate parameterization
(P31/P32).
The status word is used to feed back the terminal signal
Status word (n–set).
––> ZSW.11: Feedback signal, terminal 1
––> ZSW.12: Feedback signal, terminal 2
5 Description of the Functions
02.9905.0305.03

Siemens SIMODRIVE POSMO A Specifications

General

Brand	Siemens
Model	SIMODRIVE POSMO A
Category	Engine
Language	English