Siemens SIMOTION C - Connecting the Encoders (C230-2, C240)

Connecting
5.1 Wiring
SIMOTION C
114 Operating Instructions, 02/2012
5.1.6 Connecting the encoders (C230-2, C240)
Connecting the connecting cable
Note the following:
Note
Always use shielded data cables. The shielding must be connected with the metallic or
metallized connector housing.
The pre-assembled cable available as an accessory provides the best possible immunity to
interference and adequately dimensioned cross-sections for the power supply to the
encoders.
7KHIROORZLQJHQFRGHUVFDQEHFRQQHFWHG
,QFUHPHQWDOHQFRGHUZLWK56
52'EXLOWLQHQFRGHULQ)7
66,DEVROXWHHQFRGHU
/LQHDUVFDOHZLWK(;(
6,02'5,9(DQDORJFRQWUROXQLW).PRWRUVZLWKUHVROYHU
6,02'5,9(XQLYHUVDOZLWKDQJXODULQFUHPHQFRGHULQWHUIDFH
&RQQHFWLQJFDEOH
$[LV
&&
;
;
;
;
;
6,(0(16
;
;
&
05(6
6723
581
Figure 5-15 Encoder connections