SIMOTION C
Operating Instructions, 02/2012
185
Standards, Certificates and Approvals
A
A.1 General rules
CE marking
Our products satisfy the requirements and protection objectives of the EC
Directives and comply with the harmonized European standards (EN).
Electromagnetic compatibility
Standards for EMC are satisfied, if the EMC Installation Guideline is observed.
SIMOTION products are designed for industrial use in accordance with product standard DIN
EN 61800-3, Category C2.
cULus Approval
Listed component mark for United States and the Canada Underwriters
Laboratories (UL) according to Standard UL 508, File E164110, File E115352,
File E85972.
EMC
USA
Federal
Communications
Commission
Radio Frequency
Interference
Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Shielded Cables Shielded cables must be used with this equipment to maintain compliance with
FCC regulations.
To Next Page
Loading...
