Standards, Certificates and Approvals
A.1 General rules
SIMOTION C
186 Operating Instructions, 02/2012
USA
Modifications Changes or modifications not expressly approved by the manufacturer could
void the user’s authority to operate the equipment.
Conditions of
Operations
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CANADA
Canadian Notice This Class B digital apparatus complies with Canadian ICES-003.
Avis Canadien Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
SOUTH KOREA
For sellers or other user, please keep in mind that this device in an A-grade electromagnetic wave
device. This device is intended to be used in areas other than home.
The EMC limit values to be observed for Korea correspond to the limit values of the EMC product
standard for variable-speed electric drives EN 61800-3 of category C2 or the limit value class A,
Group 1 to EN55011. By implementing appropriate additional measures, the limit values according to
category C2 or limit value class A, Group 1, are observed. For this purpose, additional measures,
such as the use of an additional RFI suppression filter (EMC filter) may be necessary. In addition,
measures for EMC-compliant configuration of the plant are described in this Manual and/or the
Configuration Manual "EMC Installation Guideline". Please note that ultimately it is always the label
on the device that provides the decisive information on the compliance with standards.
Declaration of conformity
The current Declaration of conformity is available on the Internet at Declaration of conformity
(http://support.automation.siemens.
com/WW/view/en/10805446/134200).
General warning information
CAUTION
There is a risk of injury or of damage to assets. In hazardous areas, personal injury or
damage to assets can occur if plug-in connections are disconnected during operation.
Make sure that your system is always de-energized before disconnecting plug-in
connections in hazardous areas.
To Next Page
Loading...
