Connecting comb
You can also use a connecting comb to connect the PS 307 power supply module to the
SIMOTION C. You will find the Article Nos. of the connecting comb required in chapter Spare
parts and accessories (Page 173).
Other 24 V connections
On the PS 307 power supply, there are 24 V connections available via the connecting comb
for connecting the supply of the I/O modules.
Wiring with the connecting comb
Proceed as follows to wire the PS 307 power supply module and the SIMOTION C.
WARNING
You could come into contact with live wires if the power supply module and any additional
load power supplies are switched on.
Ensure that the system is de-energized when you wire the system!
1. Open the front doors of the PS 307 and the SIMOTION C.
2. Release the clip for the cable strain relief on the PS 307.
3. Strip the power supply cable (230 V/120 V) (stripped length of 12 mm) and connect it to
the PS 307.
4. Tighten the clip for the cable strain relief.
Connecting
6.1 Wiring
SIMOTION C
100 Operating Instructions, 11/2016, A5E33441428B
To Next Page
Loading...
Need help?
General
