Siemens SINAMICS G Series - Loading Controller and Drive Configuration

5 Installation and commissioning
Drehzahlachse mit SINA_SPEED
Entry-ID: 109485727, V1.0, 06/2017
23
 Siemens AG 2017 All rights reserved
No.
Action
Remark
4.
Load the program of the
SIMATIC controller.
1. Select the S7 controller in
the project tree.
2. Load the project into the
controller.
5.
As soon as the “Extended
download to device” dialog box
opens, proceed as follows:
1. Select the settings
required for your online
connection.
2. Select the CPU.
3. Load the configuration.
6.
Load the configuration into the
drive.
When no connection is established to the drive, assign the drive the IP address and the device
name. To do so, proceed as described in chapter 4.2.