Siemens SINAMICS G Series - Configuring the S7 Program

4 Configuration and Settings
Drehzahlachse mit SINA_SPEED
Entry-ID: 109485727, V1.0, 06/2017
19
 Siemens AG 2017 All rights reserved
4.3 Configuring the S7 program
The following step table shows how to configure a S7 program with the
“SINA_SPEED” function block.
Table 4-5: Configuring the S7 program
No.
Action
Remark
1.
Select the S7-1200 CPU in the
project tree.
-
2.
Open the libraries and select the
“SINA_SPEED” block from the
DriveLib library (V5.0) matching the
S7 controller used.
3.
Then add the block the “Program
blocks” folder in the controller.
4.
Call the “SINA_SPEED” block in the
Main OB (OB1). Assign the function
block an instance data block. The
number of the instance data block
can be selected by the user.