Siemens SINAMICS G Series - Configuration and Settings for SINAMICS; Creating Project Configuration

4 Configuration and Settings
Drehzahlachse mit SINA_SPEED
Entry-ID: 109485727, V1.0, 06/2017
14
 Siemens AG 2017 All rights reserved
4 Configuration and Settings
The step tables below describe how to configure the S7-1200 and the
SINAMICS S120 drive. The configuration of the operator panel is not described in
this chapter.
A requirement is that the software listed in Table 2-2 is installed on your PC/PG.
4.1 Creating the project configuration
Table 4-1: Creating the project configuration
No.
Action
Remark
1.
Open TIA Portal and create a new
project.
2.
Double-click on “Add new device“.
3.
Add your desired controller:
1. Select “Controller”.
2. Select the desired CPU.
3. Then click on “OK”.