Siemens SINAMICS G Series - Operating the SINAMICS Application; HMI Operation Interface

6 Operating the application example
Drehzahlachse mit SINA_SPEED
Entry-ID: 109485727, V1.0, 06/2017
25
 Siemens AG 2017 All rights reserved
6 Operating the application example
WARNING
Make sure that no persons or system components are endangered by the
moving drive.
Take appropriate measures to prevent the drive from exceeding technical or
mechanical limits.
6.1 Operation via HMI
The following operating screens are available in the HMI project for operating the
application example. The structure of these screens is shown in the figure below.
Figure 6-1: Overview of the screens
Startbild
Bedienung des
Bausteins
Systemfunktionen
Support-
Informationen
If there is no SIMATIC HMI available, the operator screens can be used in
simulation mode. In the simulation mode, the runtime of the operator panel is
displayed in a TIA framework.