6 Operating the application example
Drehzahlachse mit SINA_SPEED
Entry-ID: 109485727, V1.0, 06/2017
Siemens AG 2017 All rights reserved
6.1.2 Operating the “SINA_SPEED” block
The schematic call of the block is shown in the “SINA_SPEED” operator screen.
Figure 6-4: “SINA_SPEED” operator screen
Table 6-2: Input tags
These inputs are supplied with buttons. The names in green
indicate the inputs are enabled.
These inputs are supplied with values by input and output
fields. The values are input using the on-screen keyboard.
Table 6-3: Output tags
Active faults are indicated with the outputs in red.
Enabled outputs are indicated with green.
The current values of these outputs are indicated by output
fields.
The function principle and the admissible values of the inputs and outputs of the
block are explained in chapter 3.2.
To Next Page
Loading...
