Siemens SINAMICS G Series - Operation via Control Board

6 Operating the application example
Drehzahlachse mit SINA_SPEED
Entry-ID: 109485727, V1.0, 06/2017
29
 Siemens AG 2017 All rights reserved
Table 6-5: Buttons in the support information
Operation
Action
Activating the start screen
Activating the previous screen
Switch language to German
Switch language to English
6.2 Operating via the control board
You can also use the application example without an HMI. The watch table
“ControlSinaSpeed” has already been created in the project. The tags you can
monitor or control are the same which are also displayed at the operator panel.
Figure 6-7: “ControlSinaSpeed” control panel