Installation
3.2 System Installation
Distributed converter for SIMOGEAR geared motors
Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
33
Converter must not be used as a step or ledge
The converter has not been designed to support a substantial weight and therefore must
not be used as a step or a ledge.
Should substantial weight be placed on the system it could result in severe damage to the
equipment which could adversely affect the application and any persons coming into
contact with the system.
Note
Diagrams and illustrations
In some of the diagrams and illustrations throughout this section, the colour of componen
ts
or cables have been selected to make them more visible and do not necessarily reflect the
real colour of the component or cable. In some illustrations, components have been removed
to enhance the clarity of what is being described.
Note
Use only Non-Drive End (NDE) motor configurations
The SINAMICS G110M has been designed to be used in conjunction with NDE motors. Do
not use standard motor terminal box mountings with the SINAMICS G110M systems.
Connection and cables (Page 53)
Mechanical Installation (Page 28)
Quick Commissioning with DIP switches (Page 75)
LA/LE motors for mounting on SIMOGEAR gearboxes
(http://support.automation.siemens.com/WW/view/en/60666508
)
Unswitched and switched 24 V supply
(http://support.automation.siemens.com/WW/view/en/26986267
)
When the SINAMICS G110M is delivered as separate components, the Terminal Housing
must be fitted to the motor. To accomplish this task it is necessary to disassemble the
Terminal Housing to gain access to the motor mounting fixtures in the base of the Terminal
Housing.
To Next Page
Loading...
