Commissioning
4.4 p0015 Macros
Distributed converter for SIMOGEAR geared motors
Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
69
Switching the motor on and off in the jog mode
Figure 4-6 Jogging the motor with the factory settings
In the case of inverters with a PROFIBUS or PROFINET interface, operation can be
switched via digital input DI 3. The motor is either switched on and off via PROFIBUS – or
operated in jog mode via its digital inputs.
When a control command is received at the respective digital input, the motor rotates at
±150 rpm. The same ramp-up and ramp-down times as described above apply.
p0015 Macros
Macros for the CU240M
The macros that are available for the CU240M Control Modules are shown in the figures
below. Macro 7 is the default setting for the CU240M DP and CU240M PN Control Modules,
Macro 21 is the default settings for the CU240M USS Control Module and Macro 30 is the
default settings for the CU240M ASi Control Modules.
Figure 4-7 Macro 7 - Switch over between fieldbus and jogging using DI 3 (default DP/PN)
To Next Page
Loading...
