Commissioning
4.7 Quick commissioning with a PC
Distributed converter for SIMOGEAR geared motors
Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
87
Go online and start the commissioning Wizard
Procedure
1. Select your project and go online:
2. In the following screen form, select the inverter with which you wish to go online.
3. Once you are online, select "Commissioning" → "Commissioning Wizard":
You have started the commissioning Wizard of the inverter.
❒
The wizard only displays the "setpoint input" if you configured an inverter with PROFINET or
PROFIBUS interface.
Select whether the inverter is connected to a higher-level control via the fieldbus.
Select whether the ramp-function generator for the speed setpoint is implemented in the
higher-level control or in the inverter.
Select the control mode.
Selecting the control mode (Page 89)
Select the I/O configuration to preassign the inverter interfaces.
p0015 Macros (Page 69)
Set the applicable motor standard and the inverter supply voltage.
Select the application for the inverter:
● "[0] Load cycle with high overload for applications requiring a high dynamic performance,
e.g. conveyor systems.
● "[1] Load cycle with low overload ..." for applications that do not require a high dynamic
performance, e.g. pumps or fans.
If a braking resistor is installed, you set the maximum braking power to which the braking
resistor will be subjected.
Select your motor.
Enter the motor data according to the rating plate of your motor.
If you have selected a motor based on its article number, the data has already been entered.
Select the temperature sensor for monitoring of the motor temperature.
Define whether the inverter actuates a motor holding brake.
To Next Page
Loading...
