Installation
3.1 Mechanical Installation
Distributed converter for SIMOGEAR geared motors
28 Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
Converter must not be used as a step or ledge
The converter has not been designed to support a substantial weight and therefore must
not be used as a step or a ledge.
Should substantial weight be placed on the system it could result in severe damage to the
equipment which could adversely affect the application and any persons coming in contact
with the system.
Mechanical Installation
Dimensions of the system
The converter has two frame sizes. Frame size A (FSA) and Frame size B (FSB), the
dimensions of each frame size is given in the figure and table below.
Figure 3-1 Dimensions of the converter
Table 3- 1 Converter dimensions
To Next Page
Loading...
