Siemens SINAMICS G110M - Quick Commissioning with a PC

Commissioning
4.7 Quick commissioning with a PC
Distributed converter for SIMOGEAR geared motors
84 Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
Summary of settings
- Select
Continue
Save Settings
Settings saved
Status Screen displayed
On first ON command
-
Motor
ID is performed
4.7
Quick commissioning with a PC
The screen forms that are shown in this manual show generally valid examples. The number
of setting options available in screen forms depends on the particular inverter type.
Commissioning with a PC
The following interfaces - which are control unit dependent - are available:
Table 4- 3 Connection possibilities for a PC
Type
USB
PROFIBUS
PROFINET
PC connected to CU using
USB cable
PROFIBUS interface
PROFINET interface
Interface
Mini-USB M12 - 5 pole con-
nector
M12 - 4 pole con-
nector
Restrictions
-
up to 125 slaves
None
In the following the commissioning via USB is described.