Siemens SINAMICS G110M - Compatible Motors; General Layout SINAMICS G110 M System

Description
2.3 Compatible motors
Distributed converter for SIMOGEAR geared motors
Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
21
Option
Description
Article number
HanQ connector kit Comprises the following connectors:
• Connector cap 7/8th internal thread - used for
the 24 V power blanking cap
• HanQ blanking cap - used for the mains input
blankingcap
• M12 plastic gland - used for the EM-brake
cable entry.
6SL3566-2LA00-0GA0
Repair Switch The Repair Switch allows the motor/converter to
be isolated from the mains. This means that all
power to the motor is terminated and the con-
verter cannot start or stop the motor.
6SL3555-0PR01-0AA0
Wall Mount Kit (WMK) The WMK allows the converter to be mounted on
a wall or flat surface separate from the location of
the motor.
6SL3566-1GA00-0GA0
2.3
Compatible motors
Compatible motors for the SINAMICS G110M system
The SINAMICS G110M is designed for mounting on SIMOGEAR geared motors. It is
compatible with motors from frame size 71 to frame size 112. For an overview of which
motors can be operated with SINAMICS G110M in combination with SIMOGEAR, please
read FAQ 1097385577 at the following link:
FAQ 1097385577 (https://support.industry.siemens.com/cs/us/en/view/109738577
)
For further information on the possible SIMOGEAR geared motors in combination with the
SINAMICS G110M see the MD50.1 catalog, SIMOGEAR geared motors and DT
configurator.
2.4
General layout SINAMICS G110M system
Introduction
The locations and description of the various interface connections of the CU240M Terminal
housing (including the Control Module (CM)) and the PM240M Power Module (PM) are
detailed in the figure and table below.
The layout and interfaces of the AS-i variant is shown in a separate figure and table below.
The connections on the terminal housing are delivered with either HAN Q (pluggable) or
Glanded connectors depending on the variant that has been ordered.