Description
2.2 SINAMICS G110M converter
Distributed converter for SIMOGEAR geared motors
20 Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
Mains / 24 V DC
connections
PROFINET FS80/90 HanQ 4/2 / 7/8" 6SL3544-0PB02-1FA0
Every SINAMICS G110M is delivered with the following accessories:
● PTC connection cable - this is the extension cable used to connect the PTC wires from
the motor to the connection on the CPI board.
● EM brake cable - this the extension cable used to connect the EM brake wires from the
motor to the mains connector when the EM brake wire is too short.
● Pre-wired motor terminal cables ready for connecting to the motor terminals on the motor.
● Earthing cable for earthing the motor to the terminal housing (except FS80/90).
● PROFIBUS Communications cable for connecting the CPI board to the communications
connection on the Control Module.
SINAMICS G110M HanQ 4/2 variant
● Male and female HanQ connectors, one of which is pre-wired with pins crimped on the
other end ready for assembly.
● Blanking cap for users not wishing to utilize the power-through daisy chain.
Table 2- 3 SINAMICS G110M Options
Internal 24 V DC power supply for the CU240M
Internal braking resistor
(FSA)
Continuous braking power 7.5 W, peak power 75
W (load period t
a
=12s over a period t=240s) re-
6SL3501-0BE18-8AA0
Internal braking resistor
(FSB)
Continuous braking power 20 W, peak power 200
W (load period t
a
=12s over a period t=240s) re-
6SL3501-0BE22-0AA0
Glanded connector kit Comprises the following connectors:
• M20 screw gland - used for 24 V power sup-
ply daisy chain
• M25 plastic gland - used for the 3-phase
mains daisy chain
• M12 plastic gland - used for the EM-brake
cable entry.
6SL3566-2VA00-0GA0
To Next Page
Loading...
