Siemens SINAMICS G110M - Wiring Example for the Factory Settings

Commissioning
4.2 Wiring example for the factory settings
Distributed converter for SIMOGEAR geared motors
66 Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
Table 4- 1 Components and tools for commissioning and data backup
Component or tool
Article number
Operator Panel
IOP-2 Handheld Kit
6SL3255-0AA00-4HA1
Optical cable Required for using IOP Handheld Kit with
CU240M
3RK1922-2BP00
STARTER
1)
Commissioning tool (PC software) - Version
4.3.3 or later
DVD: 6SL3072-0AA00-0AG0
StartDrive
2)
Commissioning tool (PC software) - Version
12 or later
DVD: 6SL3072-4CA02-1XG0
PC Connection Kit Contains the 3 m USB cable necessary to
connect your converter to a PC.
6SL3255-0AA00-2CA0
SD card Optional memory card for storing and trans-
ferring the converter settings
6SL3054-4AG00-2AA0
1)
Internet: STARTER download
(http://support.automation.siemens.com/WW/view/en/26233208
)
2)
Internet:StartDrive download
(http://support.automation.siemens.com/WW/view/en/68034568
)
4.2
Wiring example for the factory settings
To ensure that the factory setting of the interfaces can be used, you must wire your drive as
shown in the following examples.
Factory pre-assignment of the interfaces on the drive
For a complete technical specification of the individual connections, please refer to following
section of this manual:
Connection and cables (Page 53)
Figure 4-2 Macro 29 - Conveyer with potentiometer and fixed setpoint (Default USS)