Commissioning
4.5 Quick Commissioning with DIP switches
Distributed converter for SIMOGEAR geared motors
78 Getting Started, 04/2018, FW V4.7 SP10, A5E36100338B AG
The DIP switches allows specific functions of the converter to be set and are shown in the
table below.
Table 4- 2 Function of the DIP switches
①
Selects current or voltage input for the analog inputs.
Temperature sensor - sets the type of temperature sensor fitted to the motor.
87 Hz characteristic - set "ON" to operate the motor with the 87 Hz characteristic.
Electromechanical (EM) brake - select on if an EM brake is fitted.
Switching frequency - the user can select one of seven different switching frequencies.
Ramp-up and ramp-down timings - user can select from 0.1 seconds to 70 seconds
PROFIBUS address DIP-switch for use with the PROFIBUS and USS variant of the CU240M.
Examples of the DIP switches and their individual settings are illustrated in the figures below.
Figure 4-24 PROFIBUS address DIP Switch
To Next Page
Loading...
