15
Mounting the Power Module in the control cabinet
Please refer to the drilling pattern provided with the Power Module
for the correct drilling centers and clearance distances above and below
the Power Module. The Power Modules can be mounted side-by-side.
However, a 1mm gap is recommended to simplify installation.
1.2 Mounting and wiring
Before starting, check to ensure the following conditions have been met:
• All required components, tools and small parts are available
• All required cables and conductors have been routed / installed in accordance with specifications
• All minimum clearances are complied with
The motor and converter must be
selected so that they match each
other. This is also the case in our
example. Further, the data from
the rating plate of the motor are
important when initially commis-
sioning the converter.
NOTE
The 5 safety regulations when working on a VSD must be strictly observed
• Disconnect
• Lock out against unintentional restart
• Verify that it really is in a no-voltage condition
• Ground and short circuit
• Cover or partition off any adjacent live parts
Example of
drilling pattern
36.5 mm (1.44")
62.3mm (2.45")
6 mm (0.23")
186 mm (7.32")
To Next Page
Loading...
